Aquest ® TDS monitor faucet for reverse osmosis systems

water filters reverse osmosis membranes
water filters, replacement cartridges, reverse osmosis membranes, water tests, complete parts department


water filters, replacement cartridges, reverse osmosis membranes for Everpure, Ametek, Culligan, RainSoft, US Filter, Pentek, Plymouth, Harmsco, Aqua-Pure, EcoWater, Hydrotech, Whirlpool, GE
Home | Replacement Water Filters | Reverse Osmosis Systems | Whole House Water Filters
 Refrigerator Water Filters | Pool and Spa Filters | RV Water Filters | Parts Department
 Installation and Trouble Shooting Guide | Gift GuideMy Account | Check Out

water filters reverse osmosis membranes
  Replacement water filters and reverse osmosis membranes - Visa accepted. Replacement water filters and reverse osmosis membranes - Master Card accepted.

Large selection of replacement water filters, reverse osmosis membranes, testing kits and water filtration repair parts.  From one water filter or reverse osmosis membrane to case quantity discounts.
LOW PRICES and FAST SHIPPING SINCE 1999 !
99.5% Of All Items In Stock For Same Day Shipping!

Replacement water filters and reverse osmosis membranes - Discover accepted. Replacement water filters and reverse osmosis membranes -Amex accepted.  
water filters reverse osmosis membranes


Aquest ® M-400D Faucet
W /TDS Monitor

(TDS = Total Dissolved Solids)


SEE DRAWINGS BELOW:


I. Mount Faucet to sink top as shown.
2. Pull Spout out of the top of the Faucet.
3. While pinching the two Locking Tabs inward, grasp the Knob with other hand and pull it away from the Faucet Base.
4. Locate the coin cell Battery Holder attached to the CB (Circuit Board).
5. Slide a fresh, new coin cell Battery (CR2032 or equivalent) into the Battery Holder. NOTE: the + side of the Battery should be contacting the Battery Holder and the -side should be contacting the CB.
6. When the Battery is installed, you will notice a sequence of flashing lights at the LED Indicator, then only the Blue (Green in some models) light flashes.
7. Make your TDS selection on the DIP Switch. See DIP Switch chart.
8. Replace the Knob by holding it over the Valve Base and aligning the vertical ridge inside the Knob with the Valve Lever.
9. Lower the Knob over the Valve Base keeping the vertical ridge aligned with the Valve Lever and centering the hole in the top of the Knob over the Locking Tabs.
10. Once everything is lined up, push the Knob all the way down until it snaps in position.
11. Re-install the Spout into the Faucet Base.
12. To make sure the Knob is installed properly, rotate it fully to the left ( clockwise from top view) and check to see the LED Indicator has stopped flashing.
13. Rotate the Knob to the right and check to see the LED Indicator begins to flash Blue (green), then rotate the Knob back to the left.
14.  Install the water line using the John Guest quick connector in the center of the faucet stem.

Aquest TDS monitor faucet for reverse osmosis systems

Aquest TDS monitor faucet for reverse osmosis systems


See the Aquest faucet order page

See The Aquest Monitor Faucet Cutaway diagram

See the Aquest DIP Switch TDS setting diagram


Be sure to check our Parts Department for important parts such as TDS Testers, Replacement Tanks, O-rings , Housing Wrenches and more parts for your reverse osmosis pure water filtration system.

Customer Service

Express Re-Order

UPS Order Tracking and Shipping Times

Testimonials

Add To Favorites

Mail Subscription Manager
Check Out

Copyright © 1999-2008 WaterFiltersOnline.com, LLC, Warren, IN 46792  U.S.A., except those displayed and owned by their respective companies.  All rights reserved.  "Compatible" Legal Disclaimer.

Send Us Email

Replacement water filters and reverse osmosis membranes