Large selection of replacement water filters, reverse osmosis membranes, testing kits and water filter system repair parts. From one water filter or membrane to case quantity discounts.

LOW PRICES and FAST SHIPPING ONLINE SINCE 1999 !

99.5% Of All Items In Stock For Same Day Shipping!

Omnipure K2505-JJ 1/4" Quick Connect Inline 5 Micron Sediment Replacement Water Filter

$12.99
In stock
Omnipure ® K2505-JJ 1/4" Quick Connect Inline 5 Micron Sediment Water Prefilter

Omnipure ® K2505-JJ 1/4" Quick Connect Inline 5 Micron Sediment Water Prefilter

Specifications

Flow Rate

.75 gpm

Maximum Operating Pressure

125 psig

Operating Temperature

2 to 38 ºC35 to 100 ºF

Rated Capacity

Dependent on Influent Water Quality

Reduction Claim

Dirt, sand, and sediment reduction

Standards

ANSI (American National Standards Institute)NSF (National Sanitation Foundation)

ANSI (American National Standards Institute) / NSF (National Sanitation Foundation) International Standards

Listed under ANSI / NSF Standard 42 for materials only.

 

General Installation / Operation / Maintenance Requirements

  • Note flow direction of filter.
  • For quick connect fittings, push scratch free tube end that has been cleanly and squarely cut into the fitting until it bottoms. Threaded fittings must be wrapped with PTFE tape before installation. Install PTFE taped fittings and tighten firmly. Use two wrenches to firmly tighten tubing.
  • Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. If leaks persist, discontinue use and call your supporting dealer.
  • Replace cartridge when rated capacity is reached, or when flow becomes too slow.
  • Install in compliance with state and local laws and regulations.

Additional Information

Cap and body are spin welded together producing a smooth, consistent seal without the use of glues or binders that can cause contamination. The result of these design and production techniques is a reliable filter that is fast and easy to install.

One of the primary uses of this product is as a system component. The benefit is derived from the fitting being molded directly into the filter cap, greatly reducing clearance. Shown here (right) is a reverse osmosis system with the traditional 12 in x 2.5 in filter configuration. Notice that all the filters are uniformly attached. This results in the most efficient use of available space and greater filtering performance in a smaller overall area.

Special Notices

  • The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
  • Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

You may also be interested in the following product(s)

Related Categories